Nano Carrier V2 Picatinny Instructions


Important note: New NANO Carriers may be stiff, making installing and removing the NANO tool slightly difficult. After a few uses, the fitment should improve.

INSTALLATION INSTRUCTIONS

  • Fully seat the hex-nut into the hex socket found on the clamp side of the carrier.
  • Place both halves onto the rail by pushing them together in between two Picatinny slots.
  • Install the screw (using a 3/32” Allen key) and tighten no more than two screw rotations.
  • Tighten to no more than 5-inch pounds (roughly 5-1/2 screw turns from “finger tight”). Thread-locker is recommended to prevent walk-out under recoil.