Plus1 for 12-Gauge Shotguns - Instructions

PLEASE READ CAREFULLY BEFORE INSTALLATION.

Step-by-Step Instructions

1. Clean the surface below the breech of your shotgun using the supplied cleaning wipe. Dry with a clean cloth.

2. With the mounting surface prepped, proceed to remove the red 3M tape-liner from the pre-installed tape strip on the back of the Plus1.

3. Place the Plus1 into position, carefully aligning it below the breech, keeping it flat and level to the chamber. The Plus1 should sit about 1/8" lower than the lip of the breech (see photo).

The front interior wall of the Plus1 should line up with the front of the ejection port, as shown:

4. Apply pressure to the Plus1 against the shotgun for at least 10 seconds to assist the bonding of the adhesive.

The adhesive reaches 50% bond strength in 20 minutes, 90% strength in 24 hours, and 100% ultimate bond strength after 72 hours.

Your Plus1 is now fully installed.

Having an issue with installation or need assistance? Send an email to our support staff.